Safety helmet cap lining and other accessories without detection standard

The state has implemented a production license system for the management of special labor supplies, that is, special labor insurance products production companies must go through the national labor insurance product production license management office, and pass inspections on the company’s production capacity, technical conditions, and production products. After that, the company can produce and sell qualified products to the factory. Each batch of product must also be tested according to the batch size, with a certain number of tests for impact absorption, puncture resistance, electrical insulation, flame retardancy, direction-finding rigidity, and antistatic performance. All tests are performed on helmets. The identification of the overall test, not the identification of a certain part.

Hard Hat Cap Lining Cannot Be Detected

GB GB 2811-89, the helmet of the various parts of the choice of materials, materials, there are specific provisions, but no testing standards, can not check the cap lining qualified or not, there is no guarantee that the replacement of the cap liner itself is qualified to meet the requirements product.

The overall quality of the helmet was not detected after the replacement of the cap liner

The safety helmet is operated by the laborer during the replacement of the cap liner, and the horizontal and vertical distances between the cap liner and the cap shell cannot be guaranteed. In addition, there is no testing equipment for the use of the unit. It is unknown whether the overall quality of the helmet can reach the standard after replacing the cap liner.

Can the use of helmets be extended?

As a result of replacing the cap liner, the user will be able to produce the knowledge that the safety cap can be used without damage. Do you not know, helmets in the wind, rain, the sun, the hat will be aging over time, the national standard provides that helmets from the date of production, plastic helmets can only allow up to two and a half years, if extended Use will make the helmet into an accidental cap, once the falling object will cause a disaster. Therefore, it is suggested that in the future revision of the helmet standards, the “forbidden replacement of cap liners or fittings” should be added, and the quality of the helmet lining should be required to ensure that the cap liner is not damaged during the service period.

Copyright statement: This article is a reprint of the online media, and it only represents the author's point of view. It has nothing to do with the China Labor Insurance Network. If news articles and comments infringe your legal rights, please call us and we will handle it in a timely manner.